Pass 350-601 Exam in First Attempt Guaranteed 2021 Dumps!
350-601 Dumps Full Questions - Exam Study Guide
NEW QUESTION 60
An engineer must ensure fabric redundancy when implementing NPV mode on a Cisco MDS 9000 Series Switch.
Which action enables fabric redundancy?
- A. Add a port channel to upstream switches.
- B. Use TE ports to connect to upstream switches.
- C. Configure the NPV devices to use an external FLOGI database.
- D. Connect the NPV devices to multiple upstream switches.
Answer: A
NEW QUESTION 61
Refer to the exhibit.
What is the result of implementing this configuration?
- A. The Fibre Channel interface is configured for synchronization distribution.
- B. The Fibre Channel interface is configuration for source distribution.
- C. The Fibre Channel interface is configured for SPAN.
- D. The Fibre Channel interface is configured for FSPF.
Answer: C
NEW QUESTION 62
Which component is disrupted when the cisco integrated Management controller is upgraded on a cisco UCS series server?
- A. SAN traffic
- B. KVM sessions
- C. Cisco UCS Manager
- D. Data traffic
Answer: B
NEW QUESTION 63
Which server policy is used to install new Cisco IMC software on a server?
- A. Cisco IMC software policy
- B. BIOS software policy
- C. hypervisor firmware policy
- D. host firmware policy
Answer: A
Explanation:
Section: Compute
NEW QUESTION 64
An engineer configures the netflow feature on a Cisco NX-OS device. The requirement is to reduce the amount of export data collected by using a sampler. Drag and drop the netflow configuration steps from the left onto implemented needed to meet these requirements on the right. Not all steps are used.
Answer:
Explanation:
NEW QUESTION 65
An engineer must recover configuration on a Cisco MDS 9000 Series switch from a previous version that was backed up to bootflash and then verify the restoration.
Drag and drop the commands on the left to the correct order on the right.
Answer:
Explanation:
NEW QUESTION 66
A DNS server with IP address 192.168.1.1 is deployed in a data center A network engineer must configure a Cisco UCS Fabric Interconnect to use this DNS. Which configuration should be applied?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 67
Refer to the exhibit.
What is configured as a result of running these commands?
- A. strict unicast RPF
- B. reverse lookup for outbound packets
- C. IP Source Guard
- D. loose unicast RPF
Answer: A
Explanation:
Section: Network
NEW QUESTION 68
Drag and drop the NAS features from the left onto the NAS descriptions on the right. Not all features are used
Answer:
Explanation:
NEW QUESTION 69
A storage engineer must configure zoning on a Cisco MDS 9000 Series switch. Drag and drop actions from the left into the order on right
Answer:
Explanation:
Explanation
A, B, F, D, C, E
NEW QUESTION 70 
Refer to the exhibit. An engineer must distribute all the host ports to use all eight configured FEX uplinks. The solution must minimize disruption if an uplink fails. Which action accomplishes this objective?
- A. Set the pinning max-links value to 8.
- B. Configure the eight uplinks in a port channel.
- C. Statically assign each host interface to a fabric uplink.
- D. Change the supported FEX type.
Answer: B
NEW QUESTION 71
Refer to the exhibit.
An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches becomes isolated. What is wrong with the implementation?
- A. E Ports on both MDS switches must be configured as F ports for the zoning to function.
- B. Different zone set names must be configured on both MDS switches.
- C. Zones are local to the MDS switch and name service must be used to activate the connection between E ports.
- D. Zones must have the same name on both MDS switches for the E ports to function.
Answer: D
NEW QUESTION 72
Refer to the exhibit.
Which backup operation type does not include the Preserve Identities feature?
- A. all configuration
- B. logical configuration
- C. system configuration
- D. full state
Answer: B
NEW QUESTION 73
Drag and drop the characteristics from the left onto the correct storage systems on the right.
Answer:
Explanation:
Explanation
2,4,5 - NAS 1,3 - SAN
NEW QUESTION 74
A network engineer must implement RBAC on Cisco MDS 9000 Series Multilayer Switches.
Drag and drop the Cisco MDS 9000 Series roles from the left onto the correct categories on the right.
Answer:
Explanation:
NEW QUESTION 75
An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the following requirements:
* Establish adjacency to the remote peer by using multicast.
* Enable OTV advertisements for VLAN 100 to the other site.
Which two commands should be configured to meet these requirements? (Choose two.)
- A. otv control-group 232.1.1.1
- B. otv site-vlan 100
- C. otv extend-vlan 100
- D. otv data-group 232.2.2.0/28
- E. otv use-adjacency-server 172.27.255.94
Answer: A,D
NEW QUESTION 76
Refer to the exhibit.
Why does the python code for Cisco NX-API print error message?
- A. The "type" is wrong in the header of the request and should be "cli_ conf".
- B. NX-API does not allow configuration for features via the requests module.
- C. The "type" is wrong is the body of the request and should be "cli_ conf".
- D. The JSON is not a supported format for the NX-API.
Answer: C
NEW QUESTION 77
An engineer must configure HTTPS secure management for Cisco UCS Manager using a key ring named kr2016 and a key size of 1024 bits. The environment consists of a primary fabric interconnect named UCS-A and a secondary fabric interconnect named UCS-B. Which command sequence must be used to accomplish this goal?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: B
Explanation:
https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/cli/config/guide/1.4.1/CLI_Config_Guide_1_4_1_chapter6.html
NEW QUESTION 78
Refer to the exhibit.
What is the reason the system-fm-vrrp checkpoint was created?
- A. The VRRP service restarted and the checkpoint was automatically created.
- B. The VRRP-enable feature has been disabled.
- C. The VRRP process crashed and the checkpoint was automatically created.
- D. The network administrator manually created it.
Answer: B
NEW QUESTION 79
AN engineer enters these commands while in EEM on a Cisco Nexus 9000 Series Switch.
event manager applet Backup-config
event timer watchdog time 1800 name timer
event cli match "copy running-config startup-config"
what is the result of applying this configuration?
- A. It executes the copy running-config startup-config command.
- B. It blocks the copy running-config startup-config command.
- C. It saves the running configuration every 1800 seconds.
- D. It generates an error because no action is mentioned.
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/system-management/b-cisco-nexu
NEW QUESTION 80
......
CCNP Data Center Free Certification Exam Material from PrepPDF with 139 Questions: https://www.preppdf.com/Cisco/350-601-prepaway-exam-dumps.html
Use Real 350-601 - 100% Cover Real Exam Questions: https://drive.google.com/open?id=1gIOAVG57TQgHZBSQemYRyDBM3C4h2sX2